Quantum Rehab Dynamo, Руководство пользователя

Страница: 39 / 59

Quantum Dynamo www.quantumrehab.com 39
V I I . O P E R A T I O N
Power Accessory Indicator
Indicates the selected power accessory. This is for optional accessories only.
Battery Condition Meter
The battery condition meter is a 10-segment illuminated display located in front of the joystick. When the lights are on, it
indicates that there is power to the Remote Plus. The lights also indicate battery status, Remote Plus operational status, and
electrical system status.
! !
! ! !
Red, yellow, and green lights lit: Batteries charged; controller and electrical system OK.
! ! ! ! !
Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.
! !
! !
!
Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.
! !
! ! !
Rapid flash of lights: Indicates an error in the controller or the electrical system. See “Remote Plus Error Codes.”
! ! ! ! !
Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you
get “ripple up and down of lights,” turn off the controller and allow the joystick to return to the neutral position. Then
turn on the controller.
NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, remind-
ing you the batteries need to be charged immediately!
Off-board Charger/Programming Socket
The off-board charger/programming socket is located on the front of the Remote Plus. If you use an off-board charger, the
charger current should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your Quantum Rehab Specialist for more information.
NOTE: Changes to the programming can only be made by the manufacturer, an authorized representative of
the manufacturer, or a Quantum Rehab Specialist.
Controller Communications Cable
The controller communications cable provides the Remote Plus with a connection to the power module.
Power Module (Not Shown)
Typically, the power module is mounted to the power base. The power module provides a power interface for the joystick
module. It routes the battery power to the motors and other powered accessories such as lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and power
interface between the power module, the lights, and/or the power seat actuator.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off the main
power if the joystick is not moved in any direction for approximately five minutes. The battery condition meter lights on the
keypad indicate sleep mode by blinking once every five seconds. To restore power and continue, push the on/off key twice.