9530/8530 Manual Version 4.5
Page 59
Once the Run/Stop button is pressed the unit will generate one set of pulses, ‘N’ on and ‘M’ off.
Pressing the Run/Stop button again will generate a second set of pulses with the width and delay
adjusted by the increments set in the Channel Advanced menu. To reset the width and delay
increments the :PULSe0:IRESet 1 command must be sent to the unit using
HyperTerminal.
Using the Burst Increment Function
In the System Mode menu:
o
Set the mode to BurstIncrement mode.
o
Set the desired number of pulses.
o
Press the Page button and set the T
0
period.
In the Channel menu:
o
Set the desired pulse width and delay.
o
Set the desired Channel Mode.
In the Channel Advanced menu:
o
Set the desired width increment step size.
o
Set the desired delay increment step size.
Via a serial interface send the :PULSe0:IRESet 1 command to initialize the incrementing
mode
Once the Run/Stop button is pressed the unit will generate one set of pulses. Pressing the
Run/Stop button again will generate a second set of pulses with the width and delay adjusted by
the increments set in the Channel Advanced menu. To reset the width and delay increments the
:PULSe0:IRESet 1 command must be sent to the unit using
HyperTerminal.
