Quail Digital Q-P7BS, Руководство по установке

Страница: 6 / 21

Q-P7BS Base functions
Registration button and registration socket
This button allows you to put the Base into registration mode. Use a pencil or narrow tipped
screwdriver to activate the button in the housing of the Base. Press the registration button for 5 seconds
to enter this mode. Pressing the wall mounted registration socket for 5 seconds does the same.
Resetting the Base or network
The Base should be reset or ‘synchronised’ whenever additional bases are added or when the system
is reconfigured for any reason or when the SIMcard is updated. To reset the system pressing the
registration button on the master Base, or the wall mounted registration button for 15 seconds, which
resets the complete network. Don’t reset the Base by removing the power adapter, it will only reset
the bases supplied from that particular socket.
Micro SD card
This card is used to store the WAV audio files triggered by the remote keypads. For instructions on
recording the audio files, naming protocol and programming of the keypads refer to page 15.
Only
use SanDisk MicroSD cards, formatted as Fat32, file size allocation 4096.
Keypad messages
The Base is fitted with an FM receiver for communication with the remote keypads. Up to 256 keypads
can work with one single base or network. For the recording of audio files, naming protocol and
programming refer to the system installation section.
Message volume adjustment
The volume adjustment is located at the bottom of the Base. This increases/decreases the audio
level of the messages played in the headsets. Use a thin flat tipped screwdriver and gently turn to
the right to increase the volume and to the left, to decrease.
RJ45 networking sockets
Use these two sockets on the top of the base to network two or more bases.
| page 6
POWER LED STATUS LED
Booting up
Base is master and ready
Base is slave and ready
Synchronization signal
receiving OK
Active call or calls on this
Base
BOTH LEDs FLASHING CORRECTIVE ACTION
Power too low to boot up Check the individual power supplies
on the network for possible failure; or
being switched off; or consider adding
an extra power supply to the network
Base in registration mode The system will time-out of this mode in
10 minutes but you can press the
registration switch to exit the
registration mode manually