Quail Digital Q-P7BS, Руководство по установке

Страница: 12 / 21

Registering the headsets
Before using the system each headset needs to be registered to the network. Thereafter, any new or
additional headset being added also has to be registered. The Pro7 Headset System can register up
to 30 headsets.
When registering one or more new headsets, follow this procedure
1 Make sure the new headset(s) has been in the charger and is fully charged.
2. Make sure all the headsets in use on the system are in range of of all the Bases on the network. If
a headset isn’t in range or has a missing or flat battery during the registration process it will be
deleted from the system. Headsets in a charger that’s in range of a Base do not need removing
from the charger during the registration process.
3. Enter the Base in registration mode either by pressing the registration button on the Base (bottom
face) or by pressing the remote registration switch on the wall for 5 seconds. Both LEDs will flash
green when the system is in registration mode.
4. Put new headset(s) only in registration mode by placing the headset on your right ear and
pressing large silver switch and volume toggle down for about 3 seconds. Wait for the blips to
change their frequency and tone to one blip every second.
5. A 3 seconds long blip signifies successful registration.
6. You may also hear a double blip tone that will indicate it is ready to use.
7. As soon as headset(s) is registered the system is ready to use. Press registration switch again to
exit registration process or leave it to time out after 10 minutes.
If there are multiple Bases on the network, the entire network will go into registration mode. This will
allow you to register the headsets from any location in the coverage area.
All consecutive Bases receive the registry of headsets from the master Base automatically.
Locating the charger
The Headset Charger should be positioned on a worktop and plugged into a socket that is a
constant 24hr power outlet . The charger should be located within range of a Base so that headsets
remain linked to the base/network at all times. The headsets do not need to be active on the charger
during the registration process but they do need to be within range to avoid being deleted duringt
the registration process.
Return headsets to the charger when not in use. Charge time is approximately 2.5 hours. When
charging, the blue light on the headset will flash every five seconds. When fully charged the blue
light is constant. Headsets will last up to 8 hours between charges, slightly less in TalkLock mode. 3
beeps every 60 seconds indicate the battery is getting low.
| page 12