October 9, 2017
7014-285A
25
CB1200 Pellet Insert
Figure 25.1
Figure 25.2 Completed View
View of "L" Bracket
installed
Figure 25.2
Open right side plane to access a 4 screw terminal block
located on the bottom right hand side next to the power
cord inlet. The center 2 screws are for the thermostat
wires. The outer 2 are the mounting screws for the ter-
minal block. (
Figure 26.1 on page 26).
G. Thermostat Installation and Operation
The kit comes standard with a wall thermostat and 25’ of
wire. If you need to run more than 25’ make sure you use
a continuous strand of 18 to 22 gauge thermostat wire. For
optimum performance your thermostat should be located on
an inside wall approximately 5’ up from the floor.
How to Install Your Wall Thermostat
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
2. Connect your thermostat wire to the W and R terminals
(see
Figure 26.2 on page 26
)
3. Screw the backer plate to the wall using the hardware
included
4. Snap the thermostat to the backer plate
5. Connect the wires to the 2 center screws on the terminal
block on the back of the product
Battery Installation and Replacement
NOTE:
2 AAA batteries are included with the thermostat
and must be installed before the appliance can be oper-
ated.
Install fresh batteries immediately when the
REPLACE
BATTERY
warning begins flashing. The warning flashes
about two months before the batteries are depleted.
Even if the warning does not appear, you should replace
batteries once a year (see
Figure 26.3 on page 26
)
.
If batteries are inserted within two minutes, the time and
day will not have to be reset. All other settings are perma-
nently stored in memory.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appli-
ance.
CAUTION
