August
1,
2018
7014-285C
27
CB1200 Pellet Insert
Figure 27.1
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
(Figure
27.1)
2. Use a drill with either a 3/16 drill bit for drywall or a 7/32
drill bit for plaster drill holes.
3. Using a hammer tap in wall anchors.
4. Route the wires through the opening in the base plate,
and hold the base against the wall while aligning up
to the holes. Attach base plate using a Phillips head
screwdriver and two screws.
5. Connect your thermostat wire to the W and R terminals
(Figure 27.2)
.
W
R
W
R
Appliance
BATTERY
BATTERY
NOTE:
Ensure bare wire ends are held ALL the way into
the terminal block while the screws are being
tightened.
6. There are two
AA ALKALINE ONLY
batteries already
installed into the thermostat; to activate, remove
black plastic tab that is located inside the battery
compartment.
7. Snap the thermostat to the base plate.
Figure 27.2
Figure 27.3
Terminal Block
Center 2 Screws for
Thermostat Wires
Power Outlet
Figure 27.4
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appliance.
CAUTION
CONNECT THERMOSTAT WIRES TO APPLIANCE:
There is a 4 screw terminal block located on the back lower
left corner of the stove directly above the power cord inlet.
The center 2 screws are for the thermostat wires
(Figure
27.4)
.
