22
April 23, 2019
7021-801B
CASTILE FREESTANDING
Figure 22.4
TERMINAL BLOCK
CENTER 2 SCREWS FOR
THERMOSTAT WIRES
POWER OUTLET
FUSE
Fuse
There is a 4 screw terminal block located on the back lower
left corner of the appliance directly above the power cord
inlet. The center 2 screws are for the thermostat wires.
Figure 22.1
Figure 22.2
Figure 22.3
1. Separate the body of the thermostat from the
mounting plate by gently pulling the two pieces apart
(Figure 22.1)
2.
Use a drill with either a 3/16 drill bit for drywall or a 7/32
drill bit for plaster drill holes.
3. Using a hammer tap in wall anchors.
4. Route the wires through the opening in the base plate,
and hold the base against the wall while aligning up
to the holes. Attach base plate using a Phillips head
screwdriver and two screws.
5.
Connect your thermostat wire to the W and R terminals
(Figure 22.2)
.
W
R
W
R
Appliance
BATTERY
BATTERY
NOTE:
Ensure bare wire ends are held ALL the way into
the terminal block while the screws are being
tightened.
6.
There are two
AA ALKALINE ONLY
batteries already
installed into the thermostat; to activate, remove
black plastic tab that is located inside the battery
compartment.
7. Snap the thermostat to the base plate.