October 14, 2013
7047-910
21
5100 I-ACC
DOUBLE-SIDED
T
APE
DOUBLE-SIDED
T
APE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Figure 21.1
Thermal
Protection
Decorative tile may
be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Figure 21.2
Figure 21.3
Figure 21.4
Part No. 841-0990, size 9” x 45” and
Part No. ADJSPT-12, size 12” x 50”
H. Zero Clearance Adjustable Trim Support,
2” to 10”
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim
Sides, Double-Sided Tape (already installed)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal
Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped.
Figure 21.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips Head screwdriver.
Figure
21.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top
of trims edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 21.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a particularly powerful bonding adhesive.
Adjustments are extremely difficult once trim has adhered
to tape. Do a dry run first without removing paper from
tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on first and then front piece.
The front piece overlaps side pieces.
NOTE: The trim in
the Flush Mount Kit is one piece.
7. Once you are satisfied with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9.
There are 3 holes in the back flange of the top to secure it
to the wall if necessary. Use the appropriate fastener for
the type of wall material, i.e., brick, sheetrock, etc.
NOTE: 3/8” ( 9.5mm)
thick tile or like material can be cut
to size and fit under lip of top trim edge for a decorative
touch.
Figure 21.3.
10. Thermal protection of 1-1/2 inches (38mm), “k” value of 0.49
and R value of 3.06 under the zero-clearance trim support.
Figure 21.4.
