QTS AN-X4-ABRIO-SCAN, Руководство пользователя

Страница: 70 / 80

Page
70
AN-X4-ABRIO-SCAN Nov 2023
The top of the screen shows the serial number and MAC Address of the AN-X4 being configured.
To configure Ethernet on the AN-X, check DHCP, Static or Factory.
DHCP
If the AN-X4 finds a DHCP server on the network, it obtains an IP address, netmask and default
gateway from the DHCP server.
To find the address assigned, look at the DHCP server or use a network tool that displays devices on
the network.
If the AN-X has been configured for DHCP and it does not find a DHCP server, it waits forever for a
DHCP server and repeatedly flashes the MS LED yellow 2 times followed by a pause. The NS LED
will be solid red.
Static IP Address
If you select static IP address, enter:
•
the IP address for the AN-X.
•
the netmask for the AN-X
•
the default gateway for your network.
You must enter a valid default gateway address even if there is no device at the gateway address on
the network.
Factory
Select Factory to return AN-X to its initial state as shipped. In Factory mode, the AN-X waits 10
seconds for a DHCP server to assign it an IP address. If it fails to obtain an IP address, it reverts to a
static IP address of 192.168.0.246.
If, after AN-X has reverted to the static address and a DHCP server comes online, AN-X obtains an IP
address from the DHCP server.
You cannot use the AN-X in factory mode. It must be set to a static IP address or to DHCP before
you can use it for applications.
Hostname
Enter a Hostname for the AN-X4. This name is used internally by AN-X and may be used to identify
the AN-X if you have a DNS server on your network. The name can be from 1 to 30 characters long.
The default hostname is ANXxxxxxx, where xxxxxx is the serial number of the AN-X module.
AN-X Firmware Select
Use Administration/AN-X Firmware Select to select a firmware (*.qtf) file the AN-X is to run from
the list. AN-X builds the list from the firmware files on the microSD card that are compatible with
the AN-X hardware.
Click SUBMIT to run the firmware you have selected. You must REBOOT the AN-X to run the
firmware you selected.