WP2P Digital– User Guide
© 2020 QTech Data Systems Ltd
4
About This User Guide
This document provides assistance with the installation and operation of the QTech Wireless Point to Point
system. Included in this document is:
How to install the WP2P modules
WP2P and repeater operation
Device Configuration
Device Specifications
Other documents that should be read in conjunction with this document include:
Installation Guide for the RSS01 solar charging environmental enclosure
Contact QTech for application notes, which can be obtained to provide guidance for specific configuration
scenarios, detailing the configuration workflow steps.
Product overview
Wireless Point to Point (WP2P) modules can be used to link electrical devices together in situations where the
physical separation or terrain between them would make direct wiring uneconomic or impractical.
The most basic WP2P system comprises two WP2P modules which have been configured as a pair. The modules
simply use their onboard radios to communicate their input state to the other module.
Each WP2P Low Power – DIGITAL module has three switch inputs and three relay outputs.
Features
3 digital inputs
3 digital outputs
900 MHz (FSK modulation) short range radio up to approximately 400m for local network
communications. Extensible up to 4000m with high gain antenna configurations.
Supports use of a single repeater for difficult terrain or range extension
USB interface for diagnostics and firmware upgrades
Solar power charging and battery operation (when supplied with QTech RSS01 Remote Solar Station
enclosure).
Firmware is field upgradeable
