25
Preliminary Specification
Monitor Output
Monitor
Sum of Monitor Input and signal from internal monitor tap point(s)
Freq. Resp. 20Hz-20KHz
+/- 0.5dB
Distortion (20Hz-20KHz)
<0.05% @ +4dBu
Noise Floor
>90dB
Output Impedance (nom)
100 Ohms
Output Load (min)
600 Ohms
Monitor Level
Control Range (nom)
0dB to -95.5dB in 0.5dB steps
Relay Outputs
2 discrete floating relay switch outputs
Connector Type
3-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration
Electromechanical Relay
Pinout
1:NC 2:NO 3: COM
Switching Capacity (nom)
1A 30VDC
Logic Outputs
4 discrete outputs
Connector Type
2-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration
Single-ended, TTL compatible
Pinout
1:+(Signal) 2:-(CHASSIS GND)
Omni Inputs
6 discrete inputs for TTL logic, voltage control or passive resistive
Connector Type
2-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration
Single-ended, ground referenced
Pinout
1:+(Signal) 2:-(CHASSIS GND)
Normal Operating Range
Reads signals between 0-5V nominally
Potentiometer Operation
Use 10K for full range
Voltage Tolerance
+/- 48V
Current Output
0.5mA with 10K pot (for passive resistive controls)
RS-232 Port
Female DB9 Connector
QSControl
Neutrik Ethercon RJ45 Ruggedized Data Connector
CobraNet
Neutrik Ethercon RJ45 Ruggedized Data Connector
Indicators
QSControl Status
Yellow Link, Tx, Rx, front panel / Green Link, Tx, Rx, rear panel
CobraNet Status
Yellow Link, TX, RX, front and rear panel
Power
Blue, front panel
Diagnostic
Red, front panel
DataPort Status (Port)
Tri-state (red, green, yellow), front panel
LCD Data Display
2 line x 16 character, backlit, front panel
Specifications are subject to change without notice.
