24
P N O s c a n
P N O s c a n
P N O s c a n
I I
I I
I I
I n s t a l l a t i o n M a n u a l
I n s t a l l a t i o n M a n u a l
I n s t a l l a t i o n M a n u a l
QRS Music Technologies, Inc. / Technical Support - 800-247-6557 / www.qrsmusic.com
Manual Rev. 1.18
C
A
B
D
E
Used in conjunction with other buttons to access the setup functions.
Green
flicker indicates that MIDI date is being outputted.
Function
B
Used to access the pedal setup mode.
Green
light indicates that pedal motion is detected.
Pedal Adjust
C
Used to access keyboard setup mode.
Green
light indicates the active mode of system.
There are three modes; QRS, Mute and MIDI Sound Module
Keyboard Adjust
D
Normally not connected. Future uses include connection to control surface and other integration.
Expansion
E
B
D
Alternately Flashing
Power
A
Press and hold for about 2.5 seconds to power the system off.
Pressing when the system is off, powers the system on.
Pressing this button for less than 2 seconds places the system in mute mode and sends a "all notes off"
command to the MIDI Out and USB ports.
This button also has multi function lights:
Orange
indicates that power is being received from the AC wall adaptor or from the USB port.
When both power sources are present the USB port will always be the primary source for system power
unless the host PC cannot deliver the needed current. In this case the AC adaptor will take over.
Green-Flicker
indicates that the USB host has recognized PNOscan
II.
Green
indicates that the USB host application is launched and is ready for use.
TUSB Interface Front Panel
Alternately flashing Function and Key Adj lights indicate that a ribbon cable is disconnected or plugged in
upside-down at either the TUSB interface or the cable coupler. At the TUSB, the silver-contact side is toward
the bottom of the TUSB box. At the cable coupler, the silver-contact side of the cables should face the
circuit board.
