QRS PNO3WB, Инструкция по эксплуатации

Страница: 3 / 12

PNO3WB
MIDI Upgrade Kit Instruc ons ‐ 83529
3
QRS Music Technologies, Inc. / Technical Support ‐ 800 ‐ 247 ‐ 6557 / www.qrsmusic.com
Insert straps through slots
Mount the PNO3WB Processor
Assemble the Magne c Bracket.
A ach the Magne c Bracket to the Piano.
Place the bracket on the PNO3WB processor.
Hold the processor on the piano in a posi on where the cables will reach.
Mark it’s posi on, remove the bracket from the processor and then screw the bracket to the piano.
Do not insert an SD card into the PNO3WB processor.
The QRS music library is embedded internally.
A ach the two antennas to the end of the PNO3WB processor.
The center RFC connector is NOT used.
Connect the Op onal Record System, if installed.
The QRS PNO3WB can “record” from the following ports:
The USB CLIENT [This port will connect to the PLX box.]
Record and playback with music so ware via a computer connec on.
MIDI IN
Record from any MIDI record system on the piano.
Connect the MIDI OUT of the exis ng MIDI Interface to the MIDI IN on PNO3WB processor.
There are NO special PNO3WB processor so ware se ngs to Record or trigger synth sounds via the PNO3’s Prac ce op on.
QRS PNOscan
The PNOscan IO port is reserved for the QRS PNOscan record system.
The 10
‐ pin ribbon cable from this PRIMARY PORT will connect directly to PNO3WB.
PNOscan func ons are built into the PNO3WB so, this PNOscan interface is not needed.