PNO3WB
MIDI Upgrade Kit Instruc ons
‐
83529
5
QRS Music Technologies, Inc. / Technical Support
‐
800
‐
247
‐
6557 / www.qrsmusic.com
Connect
the
MIDI
Cable
PianoDisc
The PianoDisc controller is not needed to play the piano from PNO3WB processor.
The PianoDisc controller IS needed to calibrate the keys and pedal solenoid.
IF the PianoDisc controller is removed, do not discard, it can be reconnected to calibrate the system.
Locate the PianoDisc’s CPU Interface on the back side of the key solenoid rail.
Connect the MIDI cable from the
MIDI
OUT
of
the
PNO3WB
processor
to
the
MIDI
IN
of
the
PianoDisc
.
Disklavier
Connect the MIDI cable from the
MIDI
OUT
of
the
PNO3WB
processor
to
the
MIDI
IN
of
the
Disklavier.
On the back of the Disklavier controller set the
HOST SELECT
switch to “MIDI”.
Some units may not have the HOST SELECT switch and you may have to make a change in the controller’s setup menu.
Connect
the
PNO3WB
Power
Adapter
Power
Adapter
The PNO3WB processor will begin to power ON as soon as it is connected to power.
Turn on the PianoDisc or Disklavier.
Connect the power adapter into the 9VDC jack on the end of the PNO3WB processor.
Connect the power adapter to an AC outlet.
PDS128 Plus
CPU Interface
Disklavier Mark
III Controller
PNO3WB
is
Powering
ON
The PNO3WB processor begins to boot as soon as it’s connected to power.
The PLX lights begin to scan as the opera ng system is loaded.
Voice prompts, announcements, should be heard in about 90 seconds.
These PNO3WB bu on lights should illuminate. [1=OFF, 2=ON solid, 3=On blinking]
PlxMV light sequence:
Power/Standby/Play—Green=Ready, Yellow = Standby, Green
‐
fl
ashing = Song is Playing.
System—Green=All Good, Yellow
‐
fl
ashing=Hand
‐
held remote control command received.
[Wired Network [LAN]
Green=Standalone & Yellow=Networked] Red=Not Networked, Red
‐
fl
ashing=resolving IP address.
I/O Mode—Indicates the Source
MIDI OUT—Sending MIDI data.
Prompts/Audio—Yellow
‐
fl
ashing=voice announcements and song audio being sent to audio outputs.
Within ninety (90) seconds
#1 “Power” light turns green
#2 “System” = green
#3 “Network” = green [The Network light indicates the status of the Wired Network(LAN) PNO3WB’s Ethernet Port connec on.]
Within two (2) minutes...
Voice
‐
Prompts should be heard from the speaker and the “Prompts” light
fl
ashes yellow.
PNO3 Power Adapter
9 Volts DC / 2 Amps
Center Posi ve
To AC outlet
Содержание PNO3WB
Страница 12: ......
