QNAP TS-1079 Pro, Руководство пользователя программного обеспечения

Страница: 92 / 321

92
Note :
Please contact the ISP or network administrator for the IP address of the primary
and the secondary DNS servers. When the NAS plays the role as a terminal and
needs to perform independent connection, for example, BT download, enter at
least one DNS server IP for proper URL connection. Otherwise, the function may
not work properly.
If you select to obtain the IP address by DHCP, there is no need to configure the
primary and the secondary DNS servers. In this case, enter "0.0.0.0".
(iii) Default Gateway
Select the gateway settings to use if both LAN ports have been connected to the
network (dual LAN NAS models only).
(iv) Port Trunking
The NAS supports port trunking which combines two Ethernet interfaces into one to
increase the bandwidth and offers load balancing and fault tolerance (also known as
failover). Load balancing is a feature which distributes the workload evenly across two
Ethernet interfaces for higher redundancy. Failover is the capability to switch over to a
standby network interface (also known as the slave interface) when the primary network
interface (also known as the master interface) does not correspond correctly to maintain
high availability.
To use port trunking on the NAS, make sure at least two LAN ports of the NAS have
been connected to the same switch and the settings described in sections (i) and (ii)
have been configured.
Follow the steps below to configure port trunking on the NAS:
1. Click "Port Trunking".
2. Select the network interfaces for a trunking group (Ethernet 1+2, Ethernet 3+4,
Ethernet 5+6, or Ethernet 7+8). Choose a port trunking mode from the drop-down
menu. The default option is Active Backup (Failover).
3. Select a port trunking group to use. Click "Apply".
4. Click "here" to connect to the login page.
5. Go to "Control Panel" > "System Settings" > "Network" > "TCP/IP".
6. Click the "Edit" button under "Edit" to edit the network settings.
Note :