QNAP TS-1079 Pro, Руководство пользователя программного обеспечения

Страница: 90 / 321

90
Under the "Network Parameters" tab on the TCP/IP Property page, configure the following
settings:
Ne twork Spe e d: Select the network transfer rate according to the network
environment to which the NAS is connected. Select auto negotiation and the NAS
will adjust the transfer rate automatically.
O bta in the IP a ddre s s s e ttings a utom a tic a lly v ia DH C P: If the network supports
DHCP, select this option and the NAS will obtain the IP address and network settings
automatically.
Us e s ta tic IP a ddre s s : To use a static IP address for network connection, enter the
IP address, subnet mask, and default gateway.
Jum bo F ra m e Se ttings (M TU): This feature is not supported by TS-509 Pro, TS-
809 Pro, and TS-809U-RP. "Jumbo Frames" refer to the Ethernet frames that are
larger than 1500 bytes. It is designed to enhance Ethernet networking throughput
and reduce the CPU utilization of large file transfers by enabling more efficient larger
payloads per packet. Maximum Transmission Unit (MTU) refers to the size (in bytes)
of the largest packet that a given layer of a communications protocol can transmit.
The NAS uses standard Ethernet frames (1500 bytes) by default. If the network
appliances support Jumbo Frame setting, select the appropriate MTU value for the
network environment. The NAS supports 4074, 7418, and 9000 bytes for MTU.
Note : The Jumbo Frame setting is valid in Gigabit network environment only. All the
network appliances connected must enable Jumbo Frame and use the same MTU value.
Adv a nc e d O ptions
A Virtual LAN (VLAN) is a group of hosts which communicate as if they were attached to
the same broadcast domain even if they were located in different physical locations. The
NAS can be joined to a VLAN and configured as a backup storage of other devices on the
same VLAN.
To join the NAS to a VLAN, select "Enable VLAN" and enter the VLAN ID (a value
between 0 and 4094). Please keep the VLAN ID safe and make sure the client devices
are able to join the VLAN. If you forgot the VLAN ID and were not able to connect to the
NAS, you would need to press the reset button of the NAS to reset the network
settings. Once the NAS is reset, the VLAN feature will be disabled. If the NAS supports
two Gigabit LAN ports and only one network interface is configured to enable VLAN, you
may also connect to the NAS via the other network interface.