Qimarox PRORUNNER Mk5, Руководство пользователя

Страница: 61 / 202

UM-PRORUNNER_Mk5-1.2-EN-US 61
Maintenance vertical conveyor
7.2.4 Monthly maintenance
/i
Product carriers Check for damage. Replace the product carrier.
Refer to section
7.8.3 .
Check if the fastening bolt on
the carrying shaft is present
and has been correctly fixed.
Clean. Refer to section 7.3 .
Curve plates Check for dirt. Clean. Refer to section 7.3 .
Check for visible deformation of
the running surface. Replace the curve plate. Refer
to section
7.8.6 (bottom side) or
section 7.8.7 (upper side).
Item Task Action when required by the
check
Item Task Action when required by the
check
Motor reductor
Follow the instructions in the
manual of the manufacturer of
the motor reductor. Check the seals for leakage. Replace the seals.
Check for visible damage. Replace the damaged parts.
Check for running sounds. Replace the motor reductor.
Refer to section
7.8.12 .
Chain Tighten the chain. Refer to sec-
tion
7.7 .
Replace the chain if the training
device is at the end of the set-
ting range. Refer to section
7.8.8 .
Lubricate the chain. Refer to
section
7.4.1 .
Sprocket wheel and slide bear-
ings Check for slack. Refer to sec-
tion
7.5 .
Replace the slide bearings of
the tensioning wheel when
there is too much slack. Refer
to section
7.8.9 .
Bearings of the wheels of the
trolley Check for slack. Refer to sec-
tion
7.8.2 .
Replace the wheels. Refer to
section
7.8.2 .
Bearings of the wheels of the
guide Check for slack. Refer to sec-
tion
7.6 .
Replace the wheels. Refer to
section
7.8.5 .
Photocells Check for visible damage. Replace the photocell if neces-
sary.
Check for loose parts. Fasten loose parts.
Clean. Refer to section 7.3 .
Inductive sensors Check for visible damage. Replace the sensor if neces-
sary.
Check for loose parts. Fasten loose parts.
Clean. Refer to section 7.3 .