QHYCCD QHY16200A, Руководство пользователя

Страница: 8 / 42

QHY16200A
That doesn't necessarily mean that the camera and your computer are not connected. In this
case, you can just wait for a minute and click 'connect' again, then you can see it will be
connected successfully. This is because it usually takes a while to load its firmware into your
computer.
4. In Menu->Camera Setup, Click "Temp Control" and set the CMOS sensor temperature. You can
enable the "Auto Control" and set the target temperature. For example here we set the
temperature to -10C. The CMOS temperature will come to -10C very fast (in about 2-3minute). If
you want to close the TEC, you can select "TEC OFF". If you just want to set the TEC power but
not the temperature. You can select "Manual" and then set the percent of the TEC power.
The CCD of QHY16200A is very big, so it takes a while to achieve the target temperature. Be
patient while you are waiting.
5. You can select which filter you are going to use by changing the position of filter wheel as
shown in the following picture.