Chapter 6
27
Note 3: Internal narrow SCSI peripherals and internal
wide SCSI peripherals can be used at the same time.
There is one exception here. When both internal SCSI
peripherals and external SCSI peripherals are used
(connected by the optional external wide SCSI cable with
bracket) at the same time, only four kinds of configuration
are executable. Please see the table below. The figure
below shows one kind of configuration.
1.
Setting JP17 for control of onboard terminators, see page
18. Besides, the terminators on the SCSI peripherals on
the both sides should be enabled (refer to the figure
below).
2.
To use external narrow SCSI peripherals, you need an
extra 50pin-68pin transferrer.
Note 4: You must assign a different SCSI ID to each
device on the SCSI bus connected to the system board.
See your SCSI device documentation for directions on
how to determine the ID and change it.
Ultra Wide SCSI devices connected to this mainboard’s
SCSI connector can be assigned ID from 0 to 15 (for 68
pin Wide SCSI connection). Normally, ID7 will be used
by the on-board host.
Internal SCSI
External SCSI
Onboard Terminators
1
Wide
Wide
Power-down
Wide
Narrow
2
Auto
Narrow
Wide
Auto
Narrow
Narrow
2
Power-down
Содержание Brilliant IV
