QDI Brilliant IV, Руководство пользователя

Страница: 17 / 67

Chapter 4
11
Chapter 4
Quick Installation
The Brilliant IV is shipped with the following manufacture default:
•
CPU frequency multiple at 3x (200/66MHz or
300/100MHz Pentium

II)
•
LAN Chip(Intel 82558) Enabled
•
SCSI Chip(Adaptec 7880) Enabled
Duplicate the following steps to perform a quick installation of your
computer.
Step1. Install CPU, Heatsink and Fan
Make sure the Clock Frequecy is set according to the
specification of CPU installed. If only 1 CPU is used, the
GTC(GTL Terminator Card) must be plugged into the other
slot. While dual proccessors are used, they should be
identical.
Step 2. Install the memory
Plug at least 1 piece of 168pin DIMM SDRAM module.
Step 3. Install VGA/AGP card and connect I/O ports
Keyboard, Floppy drive and Hard disk drive need to be
connected. If there are any other devices, such as CD-ROM,
SCSI, PS/2 Devices, Serial Devices, Parallel Devices etc.,
they may be also connected in this step.
Step 4. Connect the LEDs and Switches
Be sure the anode / cathode of LEDs are connected properly.
Step 5. Connect the power supply
Connect the ATX connector with the power supply output. Be
sure the power supply installed meets