Q Acoustics 2000i serues, Инструкция пользователя и технические характеристики

Страница: 16 / 224

Setting Up Stereo System
Check that all system connections are properly and securely made.
Connections
Ensure that the subwoofer is switched off. Set the controls to the
If no PRE OUT is available then you can use the HIGH LEVEL inputs. You
following default settings:
will need two lengths of speaker cable that are long enough to go from
Level Approximately half
the 2070Si to the speaker terminals of your amplifier. Connect the two
together ensuring that you keep the L and R channels correct and make
Crossover Minimum (50Hz) for large floorstanders
sure that the plus and minus connections are consistent at both ends.
and halfway (100Hz) for bookshelf or
small speakers
Phase Fully anti-clockwise (0° setting)
Sound Mode Music
Phase invert 0°
Auto on sensitivity Med
Speaker type Select 'Sealed' if your main speakers are
of the sealed or closed-box type. Select '
P o r t e d ' i f y o u r m a i n s p e a k e r s
have a port or vent in them.
Plug the supplied power cord into the subwoofer and then into the AC
supply socket. Switch on the power at the supply socket and then switch
the power switch on the subwoofer to 'ON'. The POWER light on the
subwoofer amplifier panel will glow and the subwoofer is operational.
Play some music you are familiar with and experiment with the Phase
invert setting and level control until you hear a good blend between the
front speakers and the subwoofer. If you can hear the subwoofer
standing out it's too loud!
Connecting the 2070Si
RIGHT LEFT
REAR LS
CENTRE LS
RIGHT LEFT
FRONT LS
AV AMPLIFIER
RIGHT SPEAKER LEFT SPEAKER
SUB
RIGHT
LEFT
HIGH LEVEL