Q Acoustics 2000i serues, Инструкция пользователя и технические характеристики

Страница: 13 / 224

Multi-Channel AV System
Connections
Set the controls to the following default settings:
Standard Connection is via the Line level RCA phono Inputs. For a typical
AV system set-up you will need a single RCA phono interconnect. As this
Level Approximately half
cable is likely to be quite long, make sure you get a good quality fully
Crossover Fully clockwise (AV setting)
screened cable. Your Q Acoustics dealer will be happy to supply you with
Phase Fully anti-clockwise (0° setting)
a suitable interconnect.
Sound Mode AV
Phase invert 0°
Auto on sensitivity Med
Speaker type No effect when crossover set to AV so
either position
Plug the supplied power cord into the subwoofer and then into the AC
supply socket. Switch on the power at the supply socket and then switch
Connect the SUBWOOFER OUTPUT on the AV amplifier to the L/Mono
the power switch on the subwoofer to 'ON'. The POWER light on the
Line input on the subwoofer, pushing the plugs firmly home to ensure a
subwoofer amplifier panel will glow and the subwoofer is operational.
good contact.
Check the settings on your AV amplifier to make sure that the sub-woofer
Setting Up
is set to 'ON ‘or YES. The sub-woofer level on the AV amplifier should be
Check that all system connections are properly and securely made.
set at its default position or 0dB. You should already have set the speaker
Ensure that the subwoofer is switched off.
sizes and positions for all the other speakers in your system. If you have
the option to set the crossover frequency on the other channels make
sure this is set appropriately to your speakers. Set the distance (or delay)
setting that is correct for the sub-woofer position you have chosen.
SUB
OUT
RIGHT LEFT
REAR LS FRONT LS CENTRE LS
RIGHT LEFT
AV AMPLIFIER SUBWOOFER
Connecting the 2070Si
LINE
IN
RIGHT
IN
LEFT /
MONO