Pyronix ATLAS 8 PLUS, Руководство по установке

Страница: 20 / 69

9A PANEL ASSEMBLY
The Atlas 8 Plus is packaged with the transformer, speaker and tamper switch in place. The speaker cover, tamper
switch pin and cable knock out should be removed from the panel prior to affixing to the wall.
Battery support tray
Wall fixing hole
Tamper switch
Wiring
knockouts
Tamper
switch pin
Wall fixing hole
+
-
Cable tie
slots
Note: Use the cable tie provided to secure the battery in place
Cut out the battery support posts and install into the cut-outs as shown depending upon the size of the battery.
9A.2 Speaker Assembly
Remove the speaker back cover. If the internal speaker is to be used inside the panel, discard the front cover. If the
speaker is to be fitted externally remove the speaker back cover from the panel. The speaker should be mounted using
the two outer holes on the back cover and then clip the front cover into place.
Fix the control panel to the wall using the screws and fitting supplied. Carefully place the PCB onto the supports and
push into place
Page 20