pyrexx PX-AR, Руководство по эксплуатации

Страница: 31 / 40

Operating Manual: PX-AR Alarm Relay
31
EN EN
For all further steps, the PX-AR
must be in its delivery condition.
f
If this is not the case, follow the
instructions listed under point 7.
"Restoring default state" on page 33.
(1) Press the configura -
tion button for approx.
1 second
(2) The Status-LED
now flashes yellow for
approx. 5 seconds.
(3) Then the LED lights up
green for approx. 3 seconds.
(4) Finally, the Status-
LED flashes yellow at
the same interval as the
PX-1C radio alarm.
4.3 Integrating into a radio group
The PX-AR cannot be the master in
a radio group. Therefore, to integrate
the PX-AR, at least one PX-1C must
be in learning mode. Perform the fol-
lowing steps to integrate the PX-AR:
4.4 Set the PX-1C radio
group into learning mode
Start learning mode, if the PX-1C
is in its as delivered condition:
f
Press and hold the radio button
until the LED lights up yellow, then
release it immediately.
Starting learning mode if the
PX-1C is already integrated
into a radio group:
f
Press and hold the radio button
until the LED lights up yellow and
wait until it goes out again. Only
then release the radio button!