NOTE! If the receiver does not blink all
red
LEDs, it means that the selected
key has not been entered into the receiver's memory, the reason may be:
•
the key has already been stored in the receiver's memory
•
the waiting time for the signal from the transmitter has been exceeded
(~8s)
NOTE! A maximum of 40 keys can be assigned to the receiver. Adding key
number 41 will delete the key saved in the memory as 1, etc. One key can be
assigned to many channels in the receiver – this allows you to control several
channels with one key.
5
Modes of operation
Each channel can work independently in one of four operating modes. In
the case of cooperation with PXM controllers, it is recommended to use the
monostable or momentary mode.
•
bi-stable
– each time you press the key, the status changes to the
opposite
•
monostable
– pressing the key activates the relay for a programmed
time in the range of 1 – 255s (for more information see section 6.
Setting the activation time in monostable mode)
•
momentary
– the relay remains on all the time when the key in the
transmitter is pressed, releasing the key will turn off the relay. For this
mode, the function is available consisting in temporarily holding the
relay in the switched on state, even if the signal from the transmitter is
7