5
Control
5.1 Button
The lamp has been equipped with button which allow for changing the
brightness level. The button have been placed at the bottom part of the
junction box, above the lamp reflector.
Depending on a situation, the diode signal the following:
•
start of the lamp – quick flickering of the diode for 2 seconds,
•
DMX signal receiving – slow flickering of the brightness adjustment
button (1Hz frequency) in the first minute after receiving the DMX
signal,
•
after the start of the lamp in case of the loss of DMX signal – diode
lights (continuously) for 1 minute,
•
if the state of DMX signal changed (if there wan no DMX signal and it
returned, or vice versa) – diode signals it for 1 minute,
•
damage of the temperature sensor module – diode does not go out
after 1 minute.
To change the brightness, press and hold down the control button. If
during the brightness adjustment the button diode starts flickering, it means
that the extreme value (minimum or maximum) has been reached. Then the
direction of adjustment changes.
It is possible to change the adjustment direction without reaching
extreme values. For example, while the lamp brightness is increased, release
8
