PXM PX091, Руководство пользователя, Страница: 8 / 11

8
8. DIMMER DESCRIPTION
Residual-current
circuit breaker
S - C6
fuses
DMX OUT / IN sockets
(the sockets can be installed
inside the dimmer)
(dimmer
binding)
On-wall mounting
metal plate
Top panel
On-wall mounting
holes (Ø16 mm)
ATTENTION! It is strongly recommended to
leave not less than 10 cm of free space under
and over the dimmer to provide a proper
ventilation!
Control panel
Top panel - XLR sockets and fans
ATTENTION! It is forbidden to unscrew the dimmer rear panel! It can cause a device serious
damage!
To install the dimmer screw down the on-wall mounting metal plate to the wall and screw off the
front lid fastened with four screws characterised with letters A, B, C and D on the illustration
above. Then hang the dimmer on the metal plate on the wall and fasten it with two screws E (see
the illustration below). After that you may screw down the dimmer front panel back.
9.1. DIMMER INSTALLATION
240
PUSH
A
B
E
PX091
12 x 1200 W
ADVANCED
CONTROL
DIMMER
A B
C D
150