Fluid Section
1)
Drop the packing’s (5) into the fluid sections (4), and screw in the packing nuts
(6) but leave finger tight until assembled with the air sections.
2)
Thread the standoffs (25) into the fluid sections (4) and tighten using pliers with
soft grip ends.
3)
Mount the 006 Kalrez o-rings (15) onto the seats (2) and push the seats into the
bottom of the fluid sections (4). When inserting the seats, work the o-ring into the
fluid body with finger to prevent shearing of the edge of the o-ring.
4)
Place the 010 Kalrez o-rings (21) into the grooves on the top of the manifold.
5)
Place the fluid sections (4) onto the manifold and assemble with the eight
machine screws (24) tightening with a 3/32” Allen Key.
*Note: Be sure the 1/8” fluid inlets will align on the face of the valve.
Assemble Sections
1)
Back out the stroke adjust bolts (19) by turning them counter clockwise until the
end of their travel.
2)
Apply a small amount of silicone grease to the end of the needles (3) and insert
them into the packing nuts (6) and slide the two sections together.
3)
Align the air holes of the air sections on the same face as the 1/8”npt fluid inlets
of the fluid section then connect the sections using the four machine screws (13)
tightening them down evenly with a 3/32” Allen key.
4)
Using the tip of a 3/32” Allen key, tighten the packing nuts (6).
Spare Parts
PVA offers standard spare parts kits for all dispensing valves. These kits are
stocked for immediate shipment and allow replacement of all wearable parts of the valve.
The spare parts kit for this valve, product number
PC1-SP
, includes the following
components:
PC1-SP
Includes:
Qty
Part Number
Description
2
V302
Seat
2
114-5247
Needle
2
V305
Packing, Teflon
4
VLV-014B
O-ring, Buna
4
VLV-008B
O-ring, Buna
2
VLV-006K
O-ring, Kalrez
2
VLV-004B
O-ring, Buna
2
VLV-010K
O-ring, Kalrez
