PureLink IPAV Pro Series, Руководство пользователя, Страница: 42 / 80

User Manual
IPAV Pro Series
35
The video source connected to the Transmitter (TX) now appears on the display
connected to the respective Receiver (RX).
If the video is not being displayed, please verify the following:

Ensure that the network switch has been properly configured.

Confirm that the display can support the input source resolution.

Verify that the HDMI cable being used is of good quality. This is particularly
important for high-bandwidths of up to 18Gbps with 4K@60Hz resolution,
requiring a "HDMI Premium High Speed" cable.
To assign a different input source to a Receiver (RX), repeat the steps mentioned
above, dragging a different TX over an RX to associate the receiver itself to the new
source device.
Note: For "Fast Switch Mode" and "Genlock Scaling", please refer to "Genlock Mode".
5.4.2 Sending a Single Source to any RX Device
To send the same source signal input to all receivers at the same time, simply drag
and drop the TX unit that the desired source is connected to onto the blue tile in the
Receiver (RX) section, labeled "All Displays".
Comment: To verify, which RX and TX are joined together, left-click on the Receiver
(RX) or Transmitter (TX) tile you want to see the connection status for. All the joined
tiles will be highlighted in blue.
5.4.3 Stopping/Starting Video
To stop video being transmitted from a Transmitter (TX), right click the gear icon of
the respective Transmitter (TX) and select "Stop Video".
To start or restart a video transmission, right click the gear icon of the respective
Transmitter (TX) and select "Start Video".