PureLink IPAV Pro Series, Руководство пользователя, Страница: 28 / 80

User Manual
IPAV Pro Series
21
③
HDMI IN: Type-A female HDMI port for HDMI video source device.
④
FIBER (10G): SFP+ port comes unequipped. Single-mode and Multi-mode duplex
LC fiber modules available (IPAV-SFP10G-MM and IPAV-SFP10G-SM)
⑤
CAT (10G): RJ45 port to connect directly to the RX or a network switch using
Cat6a / Cat7.
⑥
AUDIO: A miniXLR (5pin) port to connect a balanced audio source.
⑦
IR IN: 3-pin terminal block to connect an IR receiver for IR routing control.
⑧
IR OUT: 2-pin terminal block to connect an IR emitter for IR routing control.
Installing an OpenGear 4K IP Streaming Card:
The IPAV1200-TX OpenGear 4K IP Streaming Card should be installed into OG3 or
OGX series frame. It has Front Module and Rear Module. The Rear Module should be
installed first, and then install the Front Module.
To install a Rear Module in an OG3-FR series frame:
1) Power down the OG3 or OGX series frame.
2) Ensure that the frame is properly installed.
3) Locate the card frame slot on the rear of the frame you wish to install the
OpenGear card in.
4) Seat the bottom of the Rear Module in the seating slot at the base of the frame
back plane. Refer to the user manual of OG3 or OGX series frame for details.
5) Align the top screw of the Rear Module with the screw hole on the top edge of the
frame back plane.
T
x
R
x
FIBER(10G)
RS232
CAT(10G)
HDMI AUDIO
V S S
IR OUT IR IN
H
D
M
I
LI
N
K
IPAV1200 TXAA0
Front Module
IPAV1200 TXAC0
IPAV1200 TXAB0
Rear Module
H
D
M
I
L
IN
K
BA
R
CO
DE
2018-12-25
IPAV1200-TXAB0
P
b