Pulsar PG4500BiSRCO, Руководство оператора

Страница: 8 / 25

8
CONTROL PANEL FUNCTIONS
Oil Warning
Indicator
light
Overload
Indicator
light
AC Pilot
Indicator
light
USB Power Outlet
The Generator offers a convenient (5V DC 2.1A) USB Power Outlet to allow
charging of USB chargeable devices like Tablets, MP3 players, GPS, Digital
Cameras and other USB chargeable devices.
Oil Warning Indicator Light
When the oil falls below the minimum level, the oil warning indicator
light comes on and the engine stops automatically. The engine will not
start until the correct volume of oil is in the crankcase.
Engine Overload Indicator Light
If the engine overload indicator light comes on, the generator's wattage /
amperage capacity has been exceeded by connected electrical devices or by a
power surge. When this occurs, the green AC Pilot Indicator Light will go off
.
The
engine will continue to run, (but the red Engine Overload Indicator Light will stay
on and power will no longer be supplied to connected electrical devices.)
Note :: : : The engine overload indicator light may turn on for a few seconds when
attaching a load due to a power surge. This is normal.
USB Power Outlet
Oil Warning
Indicator
light
Overload
Indicator
light
AC Pilot
Indicator
light
Fuel Selector Switch
When the Switch is in the Gas position, the generator is ready to start with Gasoline.
When the Switch is in the LPG position, the generator is ready to start with LPG.
LPG GAS
AC Pilot Indicator Light
The green AC Pilot Indicator Light comes on when the engine starts and
generates power.
1. Disconnect any electrical devices then stop the engine.
2. Reduce the total wattage of connected electrical devices until it is within the
generator’s rated output.
3. Inspect the Air Inlet and Control Panel for any blockage. Remove blockage if
found.
4. Restart Engine.
How to Correct
Oil Warning
Indicator
light
Overload
Indicator
light
AC Pilot
Indicator
light