Pulsar PG4500BiSRCO, Руководство оператора

Страница: 14 / 25

14
OPERATION
How to Stop Engine
• Disconnect any electrical devices. All loads MUST be disconnected from the generator. Never start or stop the
engine with electrical devices plugged in to the receptacles.
• Push the One Push Start Button , o r for Remote Stop push the Stop button.
• T urn Battery ON/OFF Switch to the “OFF” position.
START
STOP
WARNING!
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
heed this warning could damage the generator and/or connected electrical devices.
• Always start the engine and let it stabilize before connecting any electrical devices.
• Disconnect all electrical devices before stopping the engine.
OFF
ON
• Push and hold the One Push Start Button for about 10 seconds.
• Wait for the start light on the control panel to flash green.
• Within 3 seconds, press any button on the remote FOB for about 1 second and release.
• Make sure the green light has stopped flashing, to indicate successful pairing.
How to pair the remote FOB
• Disconnect all electrical loads from generator.
• If ambient temperature is below 32ºF (0ºC) allow about 3 minutes for the engine to warm up.
• With the Economy switch in “ON” position, the unit returns to normal operation after the above warm up time.
• Economy switch must be in the “OFF” position when using electrical devices that require a large starting current, such
as an air compressor.
Pull cord recoils rapidly and can pull arm towards engine faster than you can let go could result in
injury.
• Pull starter cord slowly until resistance is felt; retract, then pull rapidly.
Note:
To start the generator with the Economy switch in the “ON” position
14