www.pulsar.pl
INTRE
24
5.3.2
Setting the transmission parameters
The power supply units of the EN54 series allow higher transmission speeds - instead of 19.2k
8E1 it can be set to 115.2k 8E1. The changed values apply to all settings.
The PSU fitted with LCD display enables setting the communication parameters of the serial port
from the LCD panel. To enter the setup mode, press the „SET” button from the main screen.
- use the „<” or „>” buttons to display the
PSU
menu
- press the „SET” button
- use the „<” or „>” buttons to display the
Transmission
menu
(The Transmission menu is at the bottom of the screen)
- press the „SET” button, the prompt will appear at the end of the line
- use the „>” or „<” buttons to set the transmission speed
- 9.6k 8N1
:
- 115.2k 8E1
(factory settings)
:
- 115.2k 801
- confirm by pressing the „SET” button
