www.pulsar.pl
INTRE
16
In the „IP Address” field of the „Client” interface configuration type the real IP address of the „Server” interface.
Confirm by pressing the „APPLY” button.
If the port 2101 is already in use, choose another one, e.g. 2102. Use the same port number
consistently.
Setting the serial port parameters.
The settings described in this section should be applied to both RS485-Ethernet interfaces. Select the
„Basic Serial Settings” tab at the bottom of the window and enter the same settings as in the picture below.
The power supply units of the EN54 series allow higher transmission speeds - instead of 19.2k 8E1 it
can be set to 115.2k 8E1. The changed values apply to all settings.
Fig. 17. The communication parameters of the serial port.
Confirm by pressing the „Apply” button.
Next, choose the „Advanced Serial Settings” bar in the lower part of the window and enter the settings in the „TCP
Settings” section as shown below. Confirm by pressing the „Apply” button”.
Fig. 18. Configuration of communication parameters of the serial port – the “TCP settings” tab.
