Pulsar Flow Monitor, Инструкция по эксплуатации

Страница: 41 / 61

Page 35
Alarm ID Description Setpoints
1=General (Default)
Relay goes “ON” when
the value reaches the ON
setpoint and goes “OFF”
when the value reaches
the OFF setpoint.
P2 1 3, 2 2 3 is ON
Setpoint;
P2
1 4, 2 2 4 is OFF
Setpoint
2= High
Relay goes “ON” when
the value rises to the ON
setpoint and goes “OFF”
when the value lowers to
the OFF setpoint.
ON> OFF
Relay Setpoints
P2
1 3, 2 2 3 and
P2 1 4, 2 2 4
Setpoints, can be
set in any order as
the unit ‘knows’
that you are setting
a high level alarm.
3= Hi-Hi Same as 2 = High, but
different identifier.
4= Low Relay goes “ON” when
the value lowers to the
ON setpoint and goes
“OFF” when the value
rises to the OFF setpoint. ON<OFF Relay
Setpoints
P2
1 3, 2 2 3 and
P2 1 4, 2 2 4.
Setpoints, can be
set in any order as
the unit ‘knows’
that you are setting
a low level alarm.
5= LoLo Same as 4=Lo, but
different identifier.
6= In bounds
Relay goes “ON” if
value is inside the zone
between the two
setpoints.
Relay Setpoints,
P2
1 3, 2 2 3 and
P2 1 4, 2 2 4 can be
set in any order as
the unit ‘knows’
that you are setting
an inbounds alarm.
7= Out of bounds
Relay goes “ON” if
value is outside the zone
between the two
setpoints.
Relay Setpoints
P21
3 , 2 2 3 and
P2 1 4, 2 2 4 can be
set in any order as
the unit ‘knows’
that you are setting
an out of bounds
alarm.