PTI security systems Falcon XT, Руководство по установке

Страница: 34 / 64

30
Wiegand Input Connections
There are two Wiegand device inputs on the controller circuit board.
These can be connected to most types of Wiegand output devices,
such as proximity card readers, key fobs, remote door openers, etc.
Refer to the software Help Files for more information on setting up
Wiegand inputs. The two Wiegand inputs are commonly used to
control a proximity reader controlling the entrance to the office where
the controller is located or to control a proximity card reader at the
desk that allows the proximity cards to be registered and assigned
without going out to an AI device on the property.
There are generally 8 – 10 color-coded wires that connect to a
Wiegand output device. These are connected to the controller circuit
board as necessary. Refer to the Wiegand device manufacturer’s
instructions for wire color coding and connection assignments.
+12V Connection point for the + wire on 12VDC Wiegand devices
+5V Connection point for the + wire on 5VDC Wiegand devices
Gnd/Shld Connection point for – DC wire and for the Data Ground wire
Data 0 Connection point for the Data 0 input wire
Data 1 Connection point for the Data 1 input wire
Grn LED Connection for the optional Green LED entrance light wire
Red LED Connection for the optional Red LED access denial light wire
Beeper Connection for the optional beep on entrance function wire
Hold Connection for the optional hold function wire
Tmpr/CP Connection for the optional Card Presence and/or Anti-tamper wire
PROXIMITY
READER
WIEGAND
2
DATA 0
+12V
+5V
GND/SHLD
RED LED
DATA 1
GRN LED
HOLD
TMPR/CP
BEEPER
Proximity Reader Wiegand Device
shown for reference purposes only.
Many types of Wiegand devices
could be connected here.