SMA RF Signal Loop Throughs (RF Outputs)
These two SMA connectors provide a convenient way to allow RF signals to flow out of the RF 12
Pack into another radio receiver, additional RF 12 Pack, additional RF 6 Pack or other device that
utilizes RF receiver signals (receive antenna signals)
Installing Receivers:
Installing your slot receivers is a simple operation. Make sure slot receivers are equipped with a
DB-25 connector on receivers. Depending on brand, you may also need to use a machined
adapter plate to allow the receiver to sit at the proper depth in the PSC RF 12 Pack. These include:
Lectrosonics SRB requires their SRUNI kit.
Wisycom MCR42 requires their SCK42-IK-PSC kit.
Audio Limited A10-RX must be equipped with DB25 bottom
After the receivers are fully seated into the PSC RF 12 Pack, please secure the receivers with the
receivers included M3 threaded screws. You may now connect the RF cables that feed the RF
signals into the RF receivers. The RF cables are equipped with right-angle SMA connectors.
These RF cables are no
rmally wired in a crisscross pattern. This will insure that RF antenna “A”
feeds RF input “A” on your receivers. In some cases, it may make for a cleaner mechanical layout
to wire the RF cables without the crisscross pattern. This is a perfectly acceptable RF solution
and will work just fine.
Optional Aaton Digital Interface (Aaton Hydra System)
Your PSC RF 12 Pack may be equipped with the optional Aaton Digital Interface System, (Hyrda
System). If your unit is equipped with the Aaton system, there will be a USB connector on the
right-side
panel of the unit marked as “AATON DIGITAL USB”
. You can use this connection to
connect the PSC RF 12 Pack to your Cantar X3, your Cantar Mini or to a Laptop running various
manufactures software. With this system you can remotely control the slot
receiver’s
frequency
settings, monitor RF signal strength, co-ordinate frequency sweeps, etc.
Page 6
