Powering, Internal Battery:
The PSC RF 12 Pack is designed to be powered from most any
98 or 99 Watt hour “Smart” Battery.
These smart batteries are made by various companies such RRC and Audioroot or Inspired
Energy. The Smart Battery is held in place with a stainless-steel spring clip. To remove the Smart
battery, simply pull the battery clip toward the front of the RF 12 Pack and slide the battery out.
Powering, External DC:
The PSC RF 12 Pack is equipped with a full-size, chassis 4 pin male XLR that is used for external
powering. This connector is wired for both external powering only (no battery charging) and
also for Smart battery charging. (see next paragraph below). For operating the unit from external
power only, pins 1 and 4 are used as follows:
Pin 1 = Ground (-)
Pin 4 = Positive (+12Vdc to +16Vdc)
Smart Battery Charging:
The PSC RF 12 Pack is equipped to be able to charge the internal Smart battery. The internal
charger is set up to provide up to 4 Amps of charging current. This will fully recharge a 98 or 99
Watt/hour Smart battery in about 1.5 hours. To operate the PSC RF 12 Pack and charge the
internal Smart battery, Pins 1 and 3 are used as follows:
Pin 1 = Ground (-)
Pin 3 = Po19Vdc
Please note that you must use the proper rated power supply when using the charging function.
The supplied AC power supply is rated at 19Vdc ate 7.9 Amps. If you must use another power
supply, it must be rated the same at 19Vdc at 7.9 Amps or greater current.
WARNING: THE USE OF AC POWER SUPPLIES WITH A RATING OF LESS THAN 7.9 AMPS MAY
RESULT IN DAMAGE TO THE PSC RF 12 PACK WHEN CHARGING AN INTERNAL SMART BATTERY
AND SAID DAMAGE WILL NOT BE COVERED UNDER WARRANTY.
Page 4
