DC Power Distribution:
The RF 12 Pack is equipped with a built in DC power distribution system. This allows you to power
other pieces of audio equipment from the internal Smart battery. These DC outputs are located
on the right-side panel of the RF 12 Pack. One connector has a 4 Amp limit and the others have
2.5 Amp limits. These connectors are all individually Polyfuse protected and filtered. These
outputs have a
regulated 12Vdc output
that is provided by an internal DC to DC convertor. These
outputs have a maximum total DC current output of 6 Amps.
Powering Up Unit:
Powering up (ON) the unit is as simple as flipping the main power switch upward. The main
power switch is located on the left side, lower corner of the front panel. Directly above the main
power switch is the Smart battery Fuel Gauge. This fuel gauge will light up when the unit is
powered up and when there is a smart battery installed and or if the PSC AC power supply is
connected and powered up.
Audio Outputs, Mini XLR:
The RF 12 Pack is equipped with 12 x Mini XLR male connectors. These connectors are located
on the left side panel of the PSC RF 12 Pack. These connectors will output Analog Balanced audio
signals or AES Digital Audio Signals depending on your
receiver’s
capability and settings. Please
note that AED digital signals will only appear on the odd numbered outputs.
TA3M Mini XLR Audio Outputs :
The TA3M output connectors are wired to follow industry standards:
Pin 1 = Ground
Pin 2 = Audio High (+)
Pin 3 = Audio Low (-)
