PSC Mini PowerWedge, Руководство пользователя

Страница: 24 / 72

20
Mini PowerWedge
®
Cloning
Cloning is a way to copy the setup from one Mini PowerWedge to
another. Once you have programmed the first Mini PowerWedge,
you can use it as a master to turn other Mini PowerWedges into
clones of the first one.
To program the Mini PowerWedge using cloning . . .
1. Connect a bar code reader to the input connector on the pro-
grammed Mini PowerWedge (the “master”), and set the On/
Off/Program switch to the
ON
position (see Figure 1-1 on
page 1).
2. Scan the following bar code:
*$+$-EC*
This puts the programmed Mini PowerWedge into cloning mode.
While the decoder is in cloning mode, the red and green light-emit-
ting diodes (LEDs) alternate flashing twice (that is, the flashing
sequence is green-green-red-red, green-green-red-red, and so on).
NOTE
You must use identical decoders to make clones.
For example, you cannot turn a Mini PowerWedge
into a clone of a PowerWedge 10. Also, the units you
are turning into clones must have the same version
of software as the master unit.
NOTE
You can also use one of the other programming
methods (for example, menu programming or on-
screen programming) to put the decoder into clon-
ing mode.