PSC Mini PowerWedge, Руководство пользователя

Страница: 10 / 72

6
Mini PowerWedge
®
Using a Serial Device
You can attach a serial device to the
INPUT
connector on the Mini
PowerWedge. The serial device must operate with the following set-
tings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
• End-of-record character = carriage return
To attach a serial device . . .
1. Attach a wand, laser, or CCD to the
INPUT
connector on the
Mini PowerWedge.
2. Move the On/Off/Program switch on the Mini PowerWedge
to the
ON
position.
3. Scan the following bar code with the bar code reader:
*$+$-D410EE*
This puts the Mini PowerWedge into serial input mode (see “Laser/
Input Modes” on page 8).
4. Move the On/Off/Program switch on the Mini PowerWedge
to the
OFF
position.
5. Remove the device attached to the
INPUT
connector.
6. Attach the female connector of the serial input cable (part
number 00-874-24) to the
INPUT
connector on the Mini Power-
Wedge.
7. Plug the male connector of the serial input cable into the con-
nector on the serial device.
NOTE
To make your own serial input cable, see the pinout
diagram in the Mini PowerWedge Programming Ref-
erence.