Proware EP-4643S2D2-F8S6, Руководство пользователя

Страница: 64 / 151

Fibre to SAS/SATA Disk Array
64 User Manual
3.3 Preparing the Disk Array
1. Install the disk drives, if not yet installed. Refer to Section 2.6 Disk Drive
Installation for detailed information.
2. Attach network cable to the R-Link port. Connect the other end to your network
hub or switch.
3. Connect one end of Fibre optic cable to the Host Channel port of the subsystem
and the other end to the Fibre HBA on the Host system or to the FC switch.
NOTE: If a JBOD subsystem will be connected to the Disk Array,
connect the SAS cable from the SAS Expansion Port of Disk Array
to the SAS In Port of JBOD subsystem.
3.4 Powering On
1. Plug in all the power cords into the AC Power Input Socket located at the PSFM.
The main switch button in the front panel will flash blue indicating that the power
cords are inserted.
NOTE: The subsystem is equipped with redundant, full range
power supplies with PFC (power factor correction). The system
will automatically select voltage.
NOTE: The PSFM has a 5V standby DC voltage. When the power
cord(s) is/are connected to the AC Power Input Socket, after 1
second, all Activity LEDs will flash once. When the power cord(s)
is/are disconnected from AC Power Input Socket, after 3 seconds,
all Activity LEDs will flash twice.
2. Turn on each Power On/Off Switch of the PSFM. The main switch button in the
front panel will still flashing blue.
NOTE: When the power cord connected from main power source is
inserted to the AC Power Input Socket, the Power Status LED
becomes
RED . When the switch of the PSFM is turned on, the LED
still shows RED . After the main switch in front panel is turned on,
the LED turns GREEN , which means it is functioning normally.