Attaching the Visor
1
Moisten the ends of the visor posts.
2
Push the left visor post into the round
hole on the left side of the mask.
[See figure 1]
3
Push the right visor post into the hole on
the right side of the mask.
4
Push the center posts of the visor
between the frame and the hard goggle.
5
Make sure center posts are locked into hard goggle.
Note: The gap between the visor and the top of the goggle frame is normal.
Changing the Strap
The strap is easily removed from the goggle frame. In ordinary use
and maintenance, it is necessary to remove the strap from the
goggle frame. The lens can not be changed with the strap still
attached to the goggle frame. The goggle frame may be cleaned
with the strap attached to the goggle.
Remove the Strap
1
Remove strap from mask strap retainer.
[See figure 1]
2
Grasp strap behind Switch“ lock tabs and pivot upward
until they have stopped.
[See figure 2]
3
Using finger, push Switch“ lock tabs from inside
and pop out tabs.
[See figure 3]
18
1
1
2
3
Removing the Mask from Hard Goggle
To remove the mask from the goggle frame:
1
Hold the hard goggle in one hand.
[See figure 1]
2
Beginning at top corners, pull mask up and away
from hard goggle until removed from
end retention tabs.
[See figure 2]
3
Repeat on opposite side.
To install the mask on the goggle frame:
1
Hold the hard goggle in one hand.
2
Beginning at top corners, insert mask into retention tabs
on each end of hard goggle.
3
Repeat on opposite side.
4
Grab hard goggle and align tabs into mask holes.
5
Mask should fit snuggly to hard goggle.
Inspect the mask attachment carefully. Make sure that there are no gaps between
the mask and the goggle frame.
WARNING:
Never use the goggle without
the mask and ear pieces securely attached.
Improper attachment of mask can lead to serious injury.
17
1
2
3
