Removing the Lens
[Lens replacement is easier if the visor is first removed from the goggle frame.]
Tip:
Replace your lens at least once each year. Factory applied protective coatings
on each lens surface will wear off even with gentle cleaning.
Remove the Visor
Remove the center posts from the goggle frame by pulling up on the
visor. Lift center portion of visor up and away from the goggle frame.
Remove the two side posts by carefully pulling on the visor and pushing
one post at a time up from the inside.
[The lens may be removed from the goggle frame with the visor still attached to the
mask at the two side posts.]
Remove the Mask
1
Remove strap from mask strap retainer.
[See figure 1]
2
Grasp strap behind Switch“ lock tabs and pivot upward
until they have stopped.
[See figure 2]
3
Using finger, push Switch“ lock tabs from inside
and pop out tabs.
[See figure 3]
WARNING:
Use only your hands when
changing PROTO® lenses. Use of tools is likely
to scratch or damage the lens.
14
1
2
3
Storage
WARNING:
Never store the PROTO® Switch™
Goggle system in areas that may have
chemical fumes. Gasoline, kerosene, alcohol
and other chemicals and fumes will
weaken the lens and goggle.
WARNING:
Never store your PROTO® Switch™
Goggle system in areas of extreme heat
or cold. Temperature extremes will damage
the lens and the goggle. Store your goggle
in a cool well-ventilated place.
• Store your goggle in a cool, well-ventilated place free from any
kind of industrial or household fumes.
• Do not store your goggle with dirty lenses or frames.
• Do not allow dirty goggle to set overnight without cleaning.
• Do not expose your goggle frame or lens to harmful household
or industrial fumes.
• Do not store your goggle in plastic garbage cans, garbage bags,
or any plastic container.
• Do not store your goggle in the trunk of your car.
• Do not store your goggle in direct sunlight or near heaters,
stoves or other heat sources.
13
