Fitting
WARNING:
If your goggle system does not fit
properly, it may fall off. Do not use a goggle
system that does not fit snugly.
The PROTO¤ Switch“ Goggle System is not intended for use
with eyeglasses.
¥ After you have performed the safety check of the
entire goggle system, put it on.
¥ The goggle must fit firmly on your face so that it
will not move.
¥ Check for gaps between the foam on the goggle frame
and your face. The goggle must create a seal with your face.
¥ If there are any gaps, the strap is too loose.
¥ Remove the system from your head and shorten the strap
by moving the two slides evenly apart. The two slides on the
goggle strap have teeth to retard slipping. These teeth
prevent
proper adjustment while the system is snugly on your head.
¥ Put the system on and again check for gaps.
¥ If there are no gaps but the system feels too tight,
remove the system from your head and move the
two clips evenly together.
10
5
Make sure that the lens is seated properly within the lens
frame and the hard goggle frame and that both Switch“
lock tabs are flush to the goggle frame.
6
Make sure that the strap is securely attached to the frame
(right and left).
7
Make sure the sliding adjustment clips on the strap are
not cracked or broken.
8
Make sure that the mask is securely attached
to the goggle frame.
9
If you use the visor, make sure that the visor is securely
attached to the goggle frame and mask.
WARNING:
If you have any doubt about
the condition of the PROTO® Switch™ Goggle System,
don’t use it. Take it to your local dealer
for a thorough check or send it to DYE® for inspection.
9
Safety Check Continued
