Protek Samurai 321B, Инструкция по эксплуатации

Страница: 8 / 20

05 30
N O T E S W H E N A P P LY I N G
T H E S TA RT E R B O X
DO NOT over prime the engine. This could cause a hydraulic lock and damage the engine
when the starter is applied.
• If over-primed, remove the glow plug, close the high speed needle valve, cover the head
with a rag and apply the starter to pump out excess fuel. The rag will help to prevent fuel
from coming into contact with your eyes.
Piston
Cylinder Liner
Crankshaft
Near TDC
Slight taper
When the engine is cold.
When the engine is hot.
Low Speed Needle
(Metering Needle)
Idle Screw
(Throttle Stop Screw)
Mid Needle
(Mixture Control Valve)
High Speed
Needle
(Needle Valve)
Thermo Insulator
Carburetor Restrictor (Venturi)
Ball Link
Slide Boot
Exhaust
Gasket
Glowplug
Retaining Screw
O-Ring
O-Ring
Do not allow
bottom of crankcase
to touch chassis
Chamfer inside edges of bearers
Rotate the retainer
nut gently until it stops
Tighten a further
120º - 180º
High Speed
Needle
Open
Close
approx 0.5mm
Element glows when energized
Pliers
Replace the plug when the
element does not glow or is
burnt out.
Glow Plug Igniter
Turn the high speed needle clockwise
until it stops. This is the fully closed
position. Do not force it to turn further.
Approx. 0.5mm open
factory setting with the
restrictor removed.
Fuel
Fuel Tank Side
approx 1mm
Deliver fuel to the carburetor High speed needle position when
starting the engine.
Needle
30º
Close the high speed
needle approximately
30° as needed. This
procedure will be repeated
several times throughout
the break-in process.
Idle Screw
High Speed Needle
Low Speed Needle
Open Close
Close
Open
HIGH SPEED NEEDLE LOW SPEED NEEDLE
More fuel Less fuel More fuel Less fuel
Mid Needle
Carburetor Body
Slide Valve
Carburetor Body
Low Speed Needle
Rotate the low speed needle until the head
sticks out 0.5mm from the ball link body.
This is the standard position.
Ball Link
First rotate the mid needle until its slotted
head is flush with the carburetor body. This is the
standard position.
5.5 turns out. Make adjustments with the slide in the open position.
2¾ turns out. Make adjustments with the slide in the open position!
Dirt and dust may lodge in marked places
7 8
No. Part
Number Description
1 PTK-2501 Cooling Head
2 PTK-2508 Turbo Plug Button Head
3 PTK-2509 0.1mm & 0.2mm Head Gasket/Shim Set
4 PTK-2507 Complete Piston/Sleeve/Rod Assembly
5 PTK-2503 Complete Carburetor
6 PTK-2514 Carburetor Retainer Assembly
7 PTK-2504 7x19x6mm Front Engine Bearing
8 PTK-2502 Crankcase
9 PTK-2505 14x25.4x6mm Ceramic Rear Bearing
10 PTK-2506 Crankshaft
11 PTK-2512 Rear Cover Plate O-Ring
12 PTK-2511 Rear Cover Plate
13 PTK-2542 P3 Turbo Glow Plug (Ultra Hot)
* Specifications are subject to change without notice.
* See additional option parts on Pg.33