19
Q80S_2014
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 [email protected] - www.proteco.net
DECELERATION Function
This function decelerates the leafs at the end of the opening/closing cycle.
Two modes for deceleration can be chosen:
•
Standard DECELERATION
(the gate directly slows down from standard travel to decelerated speed)
•
Soft DECELERATION
(the gate gradually slows down from standard travel to decelerated speed)
1 Use
buttons to move inside the menu, till the display shows:
2 Press button
to confirm.
3 Use
buttons to select:
DECELERATION Function
OFF
DECELERATION Function
ON
Soft DECELERATION function
ON
4
Pre
ss button
to go back to the top level menus,
then press button
again till the display shows:
or wait the timeout (20 seconds) to exit.
PHOTOCELLS TEST Function
If this function is enabled, the control panel performs a quick start-up test with the photocells to make
sure that they are in operation.
1 Use
buttons to move inside the menu, till the display shows:
2 Press button
to confirm.
3 Use
buttons to select:
PHOTOCELLS TEST Function
OFF
PHOTOCELLS TEST Function
ON
4
Pre
ss button
to go back to the top level menus,
then press button
again till the display shows:
or wait the timeout (20 seconds) to exit.
START PULSE Function
This setting makes the motor operate full power for
1 second
when starting opening to overcome
gate inertia due to cold weather or long inactivity.
1 Use
buttons to move inside the menu, till the display shows:
2 Press button
to confirm.
3 Use
buttons to select:
START PULSE Function
OFF
START PULSE Function
ON
4
Pre
ss button
to go back to the top level menus,
then press button
again till the display shows:
or wait the timeout (20 seconds) to exit.
