Q80S_2014
12
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 [email protected] - www.proteco.net
Saving a new remote control code – standard START command
1 Use buttons to move inside the menu, till the display shows:
2 Now press and hold the
remote control
and simultaneously press button
on the control panel.
The display shows the radio code position.
3 If the display shows
It means that memory is full and no further code can be stored.
Repeat steps 1) and 2) to save another remote control as START command.
4 Press button to go back to the top level menus,
then press button
again till the display shows:
Or wait the timeout (20 seconds) to exit.
4. PROGRAMMING
RADIO menu
PROGRAMMING menu
FORCE menu
FUNCTIONS menu
TIMES menu
ACCESSORIES menu
Counter (number of cycles from 00.00.00 to 99.99.99)
ENTER
SCROLL
CONFIRM
EXIT
Display Description
(max)
4.1
RADIO menu
You can store up to 64 different radio codes on this control panel .
Press button and use to select menu
then press button to enter the RADIO menu: display will show
Use
buttons to scroll the lower level menu and select:
Saving a new remote control code – PEDESTRIAN START command
1 Use buttons to move inside the menu, till the display shows:
2 Now press and hold the
remote control
and simultaneously press button
the control panel.
The display shows the radio code position.
3 If the display shows
It means that memory is full and no further code can be stored.
Repeat steps 1) and 2) to save another remote control as PEDESTRAIN START command.
4 Press button
to go back to the top level menus,
then press button
again till the display shows:
Or wait the timeout (20 seconds) to exit.
(max)
This control panel can be used with standard fix code radio transmitters as well as with rollig-code radio transmitters.
Transmitter's version musts be choosen before starting any commissioning procedure.
Once the first radio radio code has been stored into the receiver the control panel will work with such type of radio
transmitter only (fix-code OR rolling code). Reset will not be possible.
