Protec optimax 2010, Руководство по эксплуатации, Страница: 50 / 52

54 OPTIMAX
®
2010
OPTIMAX 2010 NDT
Order No. 1163 - X - Y000
The film developer OPTIMAX
®
2010 has been extended by a further unit version.
Introduction
Processing time and developer temperature of the OPTIMAX
®
2010 NDT processor
have been adjusted to the requirements of NDT-films. This results in the following
modifications compared with the OPTIMAX
®
2010 standard version.
General
To maintain constantly good film quality the NDT-roller (upper roller of last roller pair
of developer rack) must be replaced every 3 - 6 months, depending on the quantity
of films processed, the chemicals and films used. 1 spare roller is supplied with the
unit. This roller must be considered a wear part and is excluded from the guarantee.
Technical Specifications (compare page 8)
Processing time (compare page 17)
Processing time from 1.5 - 10.0 min
Developer temperature (compare page 18)
Adjustable 26 - 37 °C / 78 - 99 °F)
X: 1 50 Hz Y: 0 Version with 1 pump
2 60 Hz 2 Version with 2 pumps
Important!
Please take care that the film does not carry any dirt into the
processor.
Processing capacity:
129 films 24x30 cm (crosswise), at lowest
processing time
Process time:
1.5 - 10 min
Linear speed:
8.4 - 56.0 cm/min
Developer time:
25-164 s
Developer temperature
26 - 37 °C / 78 - 99 °F
Processing and developer time relation
Processing time (min) Developer time (s) Infeed speed (cm/min)
1,5 25 56
1,7 28 49
2,0 33 42
2,3 38 37
2,5 41 34
2,7 44 31
3,0 49 28
5,0 82 17
8,0 131 11
10,0 164 9