PROSPOTfitness Fusion SSG, Руководство пользователя

Страница: 4 / 22

STEP #2 – FRONT UPRIGHT INSTALATION (con’t)
2. Now feed (#58) Weight Bar Cable Knuckles connected to (#41, #57) Barbell Cables over
Double Groove Pulleys towards front of unit.
3. Now install (#141) Glide Roller Assembly with (#112) bolts and (#110) washers.
4. Now install (#105) Front Cable Keeper bolts with nylon sleeve with (#101) nuts, (#102)
washers. Make sure cables are not twisted.
5. Now install (#114) Rear Cable Keeper bolts with nylon sleeve with (#110) nuts, (#111)
washers. Make sure cables are not twisted.
6. Now install (#19, #32) right & left Weight Horns with (#99) bolts, (#90) flat washers and (#91)
lock nuts. Also install (#20) V-shaped Rubber Bumper Rings on Weight horns.
STEP #3 – WEIGHT STACK INSTALLATION & SENSOR WEIGHT BAR
1. Now place (#71) Bottom frame assembly onto (#53) Bottom Cross Brace according to
diagram 6.
2. Find (#143) Electronic Box Locating Board and remove (#134) Cover. Now slide two (#92)
bolts & (90) flat washers thru the two holes. Now place the (#134) Cover & (#144) Electronic
box behind (#53) Back Base Rail. Pull (#55) Base Rail Wire Harness through the (#134)
Cover’s side holes and plug into (#145) Electronic Box connectors. Make sure LED lights
line up with opening on Cover and 12V power receptacle is facing out. Now attach (134)
Cover to (#143) Locating Board with small screws provided.
3. Now slide the two bolts from the (#143) Electronic Box Locating Board thru holes and secure
with (#90) flat washers and (#91) lock nuts.
4. Remove (#1, #2, #140) Weight Stack Plates and Top Plate from their cartons and place near
the unit for installation0.
5. Insert (#6) Weight Stack Guide Rods into (#10) Guide Rod Cup Holders.
6. Add weight plates. This step is easier to perform with assistance from another person. Tilt
(#6) Weight Stack Guide Rods to the side so that the weight plates can be slid onto them.
Starting with the bottom #100 weight plate slide down on Guide Rods. Keep weight plates in
order and make sure the weight indicator numbers face inward. Repeat until all weight
plates are installed. Then install top plate with (#8) Selector Key on cord facing toward the
inside of the unit.
7. Slide (#9) Top Guide Rod Plate onto the (#6) Guide Rods and position under (#12) Top
Rail’s predrilled holes and insert (#89) bolt and (#90) flat washers. Now position (#42) Lat
Boom over these bolts and secure with (90) flat washers and (#91) lock nuts.
8. According to diagram #3, now connect (#47) Lat Cable to (#140) Top Plate threaded hole.
Thread in approximately 1/2". This can be adjusted later.
9. Now according to diagram #3, connect (#137) Low Row Cable or with (#45) Cable clip to
loop on (#71) Bottom frame assembly.
10. Now install (#3) Weight Horns to the (#1) 20 lb plate that has the threaded holes, using (#86)
bolts, (#87) flat washers and (#118) lock washers. Also add (#4) rubber disc.
Page 4